Translation Services: All the Stats, Facts, and Data You'll Ever Need to Know

image

More often than not, the appeal of having a custom floor is alluring to the consumer. If you're adamant about having the floor a perfect match to your custom stained cabinets, and you can't find a prefinished floor that goes with them, then looking at unfinished is probably an option for you. However, that's about the only reason an unfinished floor should be considered, when color is the only factor.

A few things to note when deciding between prefinished and unfinished wood floors:

1. A prefinished wood floor will have a higher quality finish than an unfinished, custom stained version. Prefinished wood floors will usually have between 4-7 coats of Aluminum Oxide and or Polyurethane applied at the factory using several treatments that include pressure and heating. Not only will the finish be incomparably better on a prefinished wood, but the factory process also rids the wood of any excess moisture. There are great custom wood flooring installers out there. Don't misunderstand me! They just can't give you them same finish quality because of limitations in the field, plain old physics, temperature, physics and chemistry.

2. Manufacturers give between a 5 and 25 year wear warranty and 5 and 15 years on the finish itself. If you go with a custom stained unfinished floor you will get a 1 year warranty at best.

3. A custom prefinished floor will take a lot longer to install. The floor has the be "aired out" longer before the job, it has to be nailed down, then sanded, then stained, then finished, and then sometimes another finish is applied. It can be a week long process sometimes. Installation of a prefinished wood floor takes about half the time versus unfinished.

4. A prefinished hardwood floor produces less off gassing and VOC's than a custom unfinished version during and after installation.

5. Unfinished hardwood will have to be refinished much quicker than factory prefinished versions. Refinishing a floor can be an expensive project.

Don't get me wrong on this! It may seem like I'm knocking unfinished, custom wood flooring. If you want to have a custom floor, that's great. However, you need to be armed with the right knowledge so you can decide if it's really the right choice for you.

Natural stone such as slate, granite, limestone, sandstone, and other materials, are some of the hardest floors to remove. Unfortunately there is no way around it, the process involves a considerable amount time and manual labor if you want to do it right.

The first thing you should do is remove and base moldings that you may have. This can be done using a crowbar, propped against a piece of wood. The wood is butted against the wall, to protect your drywall from damage.

Once you have removed the molding you should inspect the floor to see if you already have any loose tiles or weak grout lines. If it is possible to remove any of the floor material by hand do so, and use that as a starting point for the Affordable Beauty Accessories in Los Angeles, CA 90005 entire process.

The actual process of removing the tiles is done using a chisel and hand maul. The chisel should be positioned on grout lines, and struck in such a way that you create an opening where you can get at both adjacent tiles. If necessary, a small crowbar can be used to pry Professional Permit Management Services In Lady Lake FL up pieces which are particularly resistant.

If you are going to reuse the underlayment found beneath the tile, be very careful not to damage it with the chisel. Once the tile is up, you will probably have to sand down Affordable Office Cleaning Service In Roanoke VA the layer below in order to remove the resistant stone adhesives which are used.

Since removing natural stone is so difficult, sub flooring is often removed and replaced right Reliable Office Cleaning Solution In Lakewood WA along with it. This saves time since you don't have to go Best Water Heater Repair Services in Chicago, IL 60660 slow and worry about damage to this layer. It also means that resistant stone spots don't have to be chiseled or sanded, as they can just be removed with the bottom level.